Soap holder for wall mounting
Here I designed a soap holder with quick change system in FreeCAD. The holder is attached to a quick-change plate, so i...t can be removed for cleaning quickly and without tools. The small video below explains the system.
Quick change system → https://www.youmagine.com/designs/deltamount
The quick-release plate is fixed with 3 to 4mm countersunk screws or glued to a wall / tile with double-sided adhesive tape.
It is important that the drying time of the tape is observed, depending on the adhesive can last up to 72 hours, i.e. 3 days, furthermore the surface should be free of dust and grease.
The components can be printed from PLA or PETG, but all components should be made from the same material. Since PETG is more flexible, the spring mechanism will have echoed less.
The small cylinder is pressed into the hole on the back of the soap holder.
The components can be printed from PLA or PETG, but all components should be made from the same material. Since PETG is more flexible, the spring mechanism will have echoed less.
The small cylinder is pressed into the hole on the back of the soap holder.
I would be very happy about a small https://paypal.me/d23elt05a donation or a picture of your print, and would be happy if you visit my other Designs. :)