Bracelet loom 3D for print
1458 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
For the tool :
- 2 outside walls
- 30 to 60% infill depending of kid's care in his toys ;)
For the buckles :
- 2 outside walls
- no infill
Watch the follow these steps:
1- Crossing the elastic between the 2 bars
2- Add another one on top of the first without crossing
3- Put the two loops over
4- Put the buckle for later attachement.
5- Repeat steps 2 and 3...
Designer
3DMakeMe3d model description
This is a small tool to weave fun colourful bracelets out of rubber bands. This tool is for kids aged 5 or later... You'll need colourful rubber bands... of around 1 to 1.5cm in diameter. Have fun !For the tool :
- 2 outside walls
- 30 to 60% infill depending of kid's care in his toys ;)
For the buckles :
- 2 outside walls
- no infill
Watch the follow these steps:
1- Crossing the elastic between the 2 bars
2- Add another one on top of the first without crossing
3- Put the two loops over
4- Put the buckle for later attachement.
5- Repeat steps 2 and 3...
