Bungee carabiners 3D for print
1190 Views 0 Likes 0 Downloads Download
After pulling the keys out, simply pull on the slotted part of the keychain and shorten the cord again.
Takes a 4-6mm bungee cord of any length you choose.
If you run the bungee the opposite way through the slot, it makes a great adjustable bracelet
The bungee is attached by knotting each end in the designated areas of the 2 sides.
Please ask if you have any questions...
Designer
3DBROOKLYNN3d model description
The Bungee Carabiner lets you use your keys without removing them from your belt loop / backpack / etc. so you will not lose them and never have to wo...rry about dropping them.After pulling the keys out, simply pull on the slotted part of the keychain and shorten the cord again.
Takes a 4-6mm bungee cord of any length you choose.
If you run the bungee the opposite way through the slot, it makes a great adjustable bracelet
3d model print parameters
Prints without support.The bungee is attached by knotting each end in the designated areas of the 2 sides.
Please ask if you have any questions...
