Fred Flintstone is one of my favorite childhood cartoon characters.
Fred was modeled in Blender, sliced using Simplify3D and printed in ABS on a Fl...ashForge Creator X. I also used a GeckoTek plate to ensure perfect adhesion of the parts to the bed.
If you have the proper filament colors, no painting is required.
The model is 29cm tall.
Enjoy, and I hope you have a "Yaba Daba Do" time printing this!
3d model print parameters
FlashForge Creator X
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
2 shells, 10% infill
Notes:
Only the top part of the hair (hair_a.st...l) and a small piece of the tie (tie_front.stl) require supports, all other pieces should be printed without supports.
I did not require any rafts, since I use a GeckTek plate for adhesion, however I would suggest either a brim or raft be used to print the nose.
Standards