This pen cup can be printed in vase mode or spiralize outer contour in cura, or printed in normal mode. You can uncheck spiralize outer contour to pri...nt in normal mode, set top layers to 0, set infill to 0%. Bottom layers set to 3 or more. Set walls to 1 or 2 or more for a more sturdy vase if not in vase mode. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% of the stl file at 76mm wide for X and Y and Z is 112mm tall. It has not been tested for being watertight and probably isn't printed in vase mode. If you make it, please post a photo, I'd like to see your print!
Enjoy...
NoTEs .....below
3d model print parameters
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
0
Filament brand:
Tianse
Fil...ament color:
silver blue
Filament material:
pla
Notes:
The stl file is not hollow.
DON'T just download and start printing, you will get a nice solid vase, great for a paper weight! Use 0 top layers, 0% infill if not printing in vase mode. I used a wall line width of .8 and a layer height of .2 other widths might work, I haven't tried them. The print should take approximately 1 hour 50 minutes at 40mm/s using vase mode.