Chessboard 3d model for 3d printers free

1447 Views 0 Likes 0 Downloads Download

Designer

timedwards

3d model description

A chess board designed for (reasonably) easy printing and assembly using a hole-and-filament-peg method. Assembled board is 34 cm x 34 cm (13 x 13 inc...hes). Designed especially to go with my OpenSCAD Chess set
http://www.thingiverse.com/thing:585218

Update, August 22, 2015: Entered the chess set at the Montgomery County, Maryland Agricultural Fair under the category "Crafts: handmade toys and games", and won first place! Perhaps one day they will have a category "Crafts: 3D printed". . .

Update, November 29, 2019: Doug Probst (
https://www.thingiverse.com/airscapes
) has provided a very nice set of tools for helping with the chess board assembly, here:
https://www.thingiverse.com/thing:4009379
. Use the grip to hold the part board_tile while sanding. Use the filament cutter assembly with a razor blade to cut the filament pegs to exactly the right length. Thanks, Doug!

3d model print parameters

Print one piece base_plate_center and four copies each of base_plate_edge and base_plate_corner. Assemble by inserting 1.75mm filament into each hole ...on the side, and cutting it to a length of 2-3mm. The filament then becomes pegs to hold the base pieces together. Apply solvent glue and press the pieces together with a clamp. Assemble first into three separate rows, and then bond the rows together to make the completed board base. Add filament pegs to all the holes on top, cutting the filament to a length of about 1-1.5mm. Keep the distance even by using a small allen wrench or toothpick to keep your wire cutters positioned at an exact and repeatable height above the board when you make each cut. Or, see https://www.thingiverse.com/thing:4009379 for a convenient tool that you can print and assemble to get the proper length of filament for each peg. Print 64 pieces of board_tile, 32 each of two different colors. Put solvent glue on the backside of each tile, and place on the board, using a clamp or mallet to drive the tile down on the pegs. The photos show the board printed with the base done in black PLA, and the tiles done in wood filament, stained and finished dark and light. To get the wood filament to look more like real wood, I printed all the tiles standing on edge, 8 to 16 at a time positioned close together in a row, looking like a heat sink. I printed on a raft to keep the tiles firmly attached to the bed while printing. Printing on edge makes the layers form a wood-grain pattern on the tile surface, with all the layers going in the same direction and no obvious 3D-printing artifacts like a crosshatch pattern or border showing on the surface. I needed to print two perimeters, or else the infill pattern shows through on the surface when stained. Tiles were sanded thoroughly, then given two coats of stain, followed by a gloss coat, and finished by lightly sanding with fine steel wool. All finishing work on the tiles was done before final assembly. See https://www.thingiverse.com/thing:4009379 for a helpful grip that you can print that will hold the tiles while sanding, as otherwise they tend to be difficult to sand without sanding your fingers along with the tiles.