There are a lot fins going around this vase. And an uneven tilt to the layers to give the vase a different look.
This vase can be printed in vase m...ode or spiralize outer contour in cura, or printed in normal mode. You can uncheck spiralize outer contour, set top layers to 0, set infill to 0%. Bottom layers set to 3 or more. Set walls to 1 or 2 or more for a more sturdy vase if not in vase mode. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% of the stl file at 71mm wide for X and Y is 73mm and Z is 110mm tall. It has not been tested for being watertight and probably isn't printed in vase mode. If you make it, please post a photo, I'd like to see your print!
Enjoy...
(Notes below...... :)
3d model print parameters
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
0
Filament brand:
Inland or any... brand
Filament color:
light brown
Filament material:
pla
Notes:
I use cura's spiralize outer contour. Check your slicer view, make sure you are printing a hollow vase. The stl file is not hollow. Use 0 top layers, 0% infill if not printing in vase mode. I used a wall line width of .8 and a layer height of .2, other widths might work, I haven't tried them. The print should take approximately 4 hours at 40mm/s using vase mode.