This a mechanical clock that I have designed and built using 3D printed parts
Find more detailed instructions on the pdf in Files:
Clock ...One build instructions.pdf
It has hours, minutes and seconds, a Graham, or dead beat escapement, it is powered by weights, it has ratchets on the pulley to facilitate rewinding.
It will run for about 5 hours, there is a nut to fine tune the speed on the pendulum
See it here: https://youtu.be/wh0CArhOsug https://youtu.be/j6-ea6O72f4 https://youtu.be/KoyZZXEglnw
Designed with Fusion 360
Sliced with Cura
Printed in PLA on Anet A8 with Solutech 3D
3D printed, Graham, Escapement, Deadbeat, mechanical clock
3d model print parameters
0.2 mm, PLA
About 30 cm high
20 to 30 hours to print all the parts
Again look for Clock One build instructions.pdf in Files for additional hardware...