Collet drill stop (<1mm to 14mm) 3D for print
4670 Views 2 Likes 1 Downloads Download the piece here from 3dforprint
A drill stop loosely based on an ER20 collet.
Select the appropriately sized colle...t for your drill bit, insert it in to the nuts and tighten down over your drill bit. It clamps firmly over a large area which means a low probability of it coming loose or moving. In addition collets are more concentric with the axis of drill rotation so if you're drilling wood, you have a much lower likelihood of marring the surface.
It does a much better job than those metal-rings-with-set-screw that are common.
Nuts are knurled for easy hand tightening/removal. I recommend putting a bit of PTFE lube or vaseline (which is what I did) on the threads and taper (which are M28x2).
The collets themselves should be +/- 1mm of flex; if you put the drill in and tighten down all the way and you can still move it, you should be using a smaller collet.
If you make the nuts out of PETG as well and don't lubricate, ...PETG tends to 'grab' itself so watch out for that.
Print the collets themselves wide end down for maximum bed adhesion, especially on the 13mm collet which doesn't have a lot of surface area to begin with!
Designer
Adam Harrison3d model description
A drill stop that won't slip or damage your wood or your drill.A drill stop loosely based on an ER20 collet.
Select the appropriately sized colle...t for your drill bit, insert it in to the nuts and tighten down over your drill bit. It clamps firmly over a large area which means a low probability of it coming loose or moving. In addition collets are more concentric with the axis of drill rotation so if you're drilling wood, you have a much lower likelihood of marring the surface.
It does a much better job than those metal-rings-with-set-screw that are common.
Nuts are knurled for easy hand tightening/removal. I recommend putting a bit of PTFE lube or vaseline (which is what I did) on the threads and taper (which are M28x2).
The collets themselves should be +/- 1mm of flex; if you put the drill in and tighten down all the way and you can still move it, you should be using a smaller collet.
3d model print parameters
I recommend printing the collets in PETG @ 100% infill for durability and flexibility.If you make the nuts out of PETG as well and don't lubricate, ...PETG tends to 'grab' itself so watch out for that.
Print the collets themselves wide end down for maximum bed adhesion, especially on the 13mm collet which doesn't have a lot of surface area to begin with!
