3d printed otoscope 3D for print
2499 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
A full description of this model and assembly instructions are listed at http://www.appropedia.org/Appropedia:3D_Printed_Otoscope
The main otoscope body weights 20 grams.
The battery cover weights 6 grams.
The switch cover weights 2 grams.
The circular base on ...which the lens assembly and the speculum mounts weights 5 grams.
The ear piece weights 3 grams.
The lens assembly weights 3 grams.
Other Parts:
A SMD pushbutton switch is used to activate the otoscope's light. The approximate cost of this part is $0.57.
A white LED is used to shine light into the ear.
A 220 ohm resistor is used to limit current draw.
A 38mm diameter, 150mm focal length concave lens in used.
About half a meter of 22 gauge solid core wire is used.
Designer
amwallis3d model description
An otoscope is simple device used in the diagnosis of ear, nose, and throat diseases. It is essentially a magnification lens with a light and speculum... to help open orifices and direct the light.A full description of this model and assembly instructions are listed at http://www.appropedia.org/Appropedia:3D_Printed_Otoscope
3d model print parameters
Printed Parts:The main otoscope body weights 20 grams.
The battery cover weights 6 grams.
The switch cover weights 2 grams.
The circular base on ...which the lens assembly and the speculum mounts weights 5 grams.
The ear piece weights 3 grams.
The lens assembly weights 3 grams.
Other Parts:
A SMD pushbutton switch is used to activate the otoscope's light. The approximate cost of this part is $0.57.
A white LED is used to shine light into the ear.
A 220 ohm resistor is used to limit current draw.
A 38mm diameter, 150mm focal length concave lens in used.
About half a meter of 22 gauge solid core wire is used.
