Linux doorbell (raspberry a+) 3d model for 3d printers free

1135 Views 0 Likes 0 Downloads Download

Designer

uli

3d model description

Doorbell with a Raspberry Pi Model A+ inside plus WiFi dongle to upload new Sounds
I got annoyed by our
doorbell (very loud and heartstopping schril...l sound) and I startet
building one using a arduino controller but then I realised that it
would be much more fun to be able to change/ install doorbell sounds via
network on the doorbell, no SD card removing and plugging into the
cardreader and plugging back in, just ssh or ftp into your doorbell and
upload a new soundfile!

When the new Raspberry Pi model A+ came out it was setteled and I needed a nice enclosure for the electronics and the two loudspeakers.

Printing the case isn't easy but its doable, I included my gcode file created with Simplify3D for my Makergear M2 printer. I printed this with PLA and used a raft.

The Raspberry Pi Model A+ is mounted on two slides (see included file) which fit into the enclosure.

The doorbell button is connected to GPIO7 and is beeing read via event_detect (interrupt) in python.

The loudspeakers are driven by a Stereo 3.7W Class D Audio Amplifier - MAX98306 which I bought here:

http://www.exp-tech.de/Shields/Audio/Stereo-3-7W-Class-D-Audio-Amplifier-MAX98306.html

The loudspeakers are 3" 4 Ohms 3Watt and have to be glued into the case:

http://www.exp-tech.de/Zubehoer/Sonstige-101/Lautsprecher-3-Durchmesser-4-Ohm-3-Watt.html
Usually in Germany there is a little 8V/1A AC transformer in the electrical cabinet for the standard doorbell. I replaced it with a 5V/ 2.4A DC switching supply for DIN-Rail from Reichelt electronics:

https://secure.reichelt.de/Schaltnetzteile-fuer-Hut-Schiene/MW-DR-15-5/3//index.html?ACTION=3&GROUPID=6539&ARTICLE=148095&SEARCH=MW%20DR-15-5&OFFSET=500&WKID=0&