Drip emitter v2 (no wings) - 3dponics emitters & plugs 3D for print
1133 Views 0 Likes 1 Downloads Download
Version 2 of the Drip Emitter is used to drain excess water from pots that have a hole at the bottom. It fits snuggly inside the hole--all you have to do is snap it into place. For an extra secure seal, you can use silicone around the edges. You can then connect a long piece of tubing to the end of the Emitter and direct it into a large container or reservoir, which will collect the excess water. The thicker nozzle allows for a better, tighter fit with the flexible tubing. Know how to make this part better? Have ideas for new parts? Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260) to take 3Dponics to the next level!
Designer
3Dponics3d model description
Version 2 of the Drip Emitter is used to drain excess water from pots that have a hole at the bottom. Want to know how much it would cost to print thi...s part? Visit https://www.3Dprintler.comVersion 2 of the Drip Emitter is used to drain excess water from pots that have a hole at the bottom. It fits snuggly inside the hole--all you have to do is snap it into place. For an extra secure seal, you can use silicone around the edges. You can then connect a long piece of tubing to the end of the Emitter and direct it into a large container or reservoir, which will collect the excess water. The thicker nozzle allows for a better, tighter fit with the flexible tubing. Know how to make this part better? Have ideas for new parts? Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260) to take 3Dponics to the next level!
