Motor corner 3D for print
899 Views 0 Likes 0 Downloads Download
This is a sturdy, simple-to-install, single piece direct drive conversion bracket for the Ultimaker. It mounts to th...e UM without any modification to the frame. Reduces backlash, simplifies maintainence, puts the motors in a place that is easier to keep cool.
**Instructions:**
- Loosely mount this to the frame, install the rods and couplers, and then mount the motors. - Tighten everything up after confirming that alignments are good. - Build a new firmware using [Ginge's Marlin Builder](http://marlinbuilder.robotfuzz.com/) and uncheck "Invert Axis: X". - Flash this new firmware using Cura
***Note*** - *Also worth mentioning... a direct drive conversion does make the machine slightly louder.*
- [8mm rod](http://www.mcmaster.com/#6112k15/=pvurun)
- 5mm to 8mm fle...xible couplers (Many sources - Adafruit, Amazon)
Designer
nhfoley3d model description
Direct Drive Mount for UltimakerThis is a sturdy, simple-to-install, single piece direct drive conversion bracket for the Ultimaker. It mounts to th...e UM without any modification to the frame. Reduces backlash, simplifies maintainence, puts the motors in a place that is easier to keep cool.
**Instructions:**
- Loosely mount this to the frame, install the rods and couplers, and then mount the motors. - Tighten everything up after confirming that alignments are good. - Build a new firmware using [Ginge's Marlin Builder](http://marlinbuilder.robotfuzz.com/) and uncheck "Invert Axis: X". - Flash this new firmware using Cura
***Note*** - *Also worth mentioning... a direct drive conversion does make the machine slightly louder.*
3d model print parameters
- [M3 x 20mm hex head cap screws](http://www.mcmaster.com/#93635a017/=pvuoxm)- [8mm rod](http://www.mcmaster.com/#6112k15/=pvurun)
- 5mm to 8mm fle...xible couplers (Many sources - Adafruit, Amazon)
