Carbonoid's washi tape box 3D for print
849 Views 0 Likes 0 Downloads Download
This 3D printable box stores up to ten 50 x 15 mm and three 50 x 9 mm Washi Tape rolls....
===============
2 x M3 threaded brass insert
2 x M3 x 35 mm hex screw
2 x M3 nylon washer
A few hundred grams of filament.
I...nstructions:
==========
1. 3D print all parts.
2. Insert brass insert into the bottom part.
3. Screw top part to bottom part with the two hex screws. Use a washer under each screw.
4. Insert the clip in the top part.
5. Fill the box with Washi Tape rolls and have fun!
Designer
Alex Skoruppa3d model description
A box for storing Washi Tape Rolls.This 3D printable box stores up to ten 50 x 15 mm and three 50 x 9 mm Washi Tape rolls....
3d model print parameters
Materials needed:===============
2 x M3 threaded brass insert
2 x M3 x 35 mm hex screw
2 x M3 nylon washer
A few hundred grams of filament.
I...nstructions:
==========
1. 3D print all parts.
2. Insert brass insert into the bottom part.
3. Screw top part to bottom part with the two hex screws. Use a washer under each screw.
4. Insert the clip in the top part.
5. Fill the box with Washi Tape rolls and have fun!
