Hand water pump 3D for print
6187 Views 2 Likes 1 Downloads Download the piece here from 3dforprint
Old style hand pump, designed to fit o...nto a large water bottle. Will work anywhere.Tested it in the sink see the video below.
Both need to be over 8mm in Diameter.
One of the balls can be up to 1in. Though smaller the bet...ter.
2 or 1 #17 Oring.
(http://www.homedepot.com/p/DANCO-17-O-Rings-10-Pack-96734/100261428)
It should work without the oring just not as well :)
Designed to fit onto 1/2IN ID tubing. The pump primes easily and the length of hose depends on how well of a seal you are able to make.
You should be able to figure out how to put it together. Part 13 is the oring, if you have rubber type filament perhaps you can just print one.
Designer
Cleven3d model description
Old style hand pump, designed to fit onto a large water bottle. Will work anywhere. Read the Bill of MaterialsOld style hand pump, designed to fit o...nto a large water bottle. Will work anywhere.Tested it in the sink see the video below.
3d model print parameters
2 marbles or balls, find something to plug the hole!Both need to be over 8mm in Diameter.
One of the balls can be up to 1in. Though smaller the bet...ter.
2 or 1 #17 Oring.
(http://www.homedepot.com/p/DANCO-17-O-Rings-10-Pack-96734/100261428)
It should work without the oring just not as well :)
Designed to fit onto 1/2IN ID tubing. The pump primes easily and the length of hose depends on how well of a seal you are able to make.
You should be able to figure out how to put it together. Part 13 is the oring, if you have rubber type filament perhaps you can just print one.
