My goal with this thing was to make a clamp that was as strong as possible, with 3d printed parts only. For this, careful consideration needed to be m...ade so that each part respects the grain of the 3d print. It is, however, still a 3d printed plastic clamp, so don't get too crazy with it!
3d model print parameters
I printed everything with standard draft settings, in PLA. Through testing, I found that the small "SlideHinge" parts are always the first things to f...ail. They break off at the very tip of the end that captures the rotating knob. So if you wanted it stronger with minimal changes, you could print the "SlideHinge" part solid.
Assembly video: https://youtu.be/MIiluSksuhI
Watch this thing crushing stuff: https://youtu.be/ECYQ5PWOezY