Table support for headset 3D for print
818 Views 0 Likes 0 Downloads Download
Hold headphones and its wire to the border or the table.
Print details:
Tested in PLA in 0.2mm layer:
- No small details... so a 0.2mm layer high is ok (0.4 mm hotend)
- Since PLA is not very strong it is recommended >=25% infill that way the piece won't suffer if the screw is tight.
- No support needed
- I additionally used just a bit of "Pritt Multi Tack" to ensure the piece won't move because my table is quiet slippery (even though the screw is tight enough)
Designer
Yaco3d model description
Headphones table holderHold headphones and its wire to the border or the table.
Print details:
Tested in PLA in 0.2mm layer:
- No small details... so a 0.2mm layer high is ok (0.4 mm hotend)
- Since PLA is not very strong it is recommended >=25% infill that way the piece won't suffer if the screw is tight.
- No support needed
- I additionally used just a bit of "Pritt Multi Tack" to ensure the piece won't move because my table is quiet slippery (even though the screw is tight enough)
