Knot a vase 3D for print
5309 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
See here for stable download: https://thangs.com/mythangs/file/28152
The lattice struct...ures are between 1.8mm – 2.0mm in diameter, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
Designer
DaveMakesStuff3d model description
Despite what you might think, this is “Knot a Vase.”See here for stable download: https://thangs.com/mythangs/file/28152
The lattice struct...ures are between 1.8mm – 2.0mm in diameter, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
