Knurled twist container - f412 remix 3D for print
1530 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
So I figured that I could have a 4mm band screw on then be glued with a few dots of super glue to the bottom part. Then the top just needed to be 4mm shorter to have the same overall height and snug fit.
Additionally I thought the inner cavity was smaller than it could be. I was able to increase the inner diameter by 5 mm to a total of 30mm (from 25mm). This makes it more viable for some small storage without affecting strength.
So there are 3 files, one for the new bottom that was wider inner diameter. This can be used with already printed top parts if you dont want the colored band. If you want the colored band, you can print the band part and the new top part that is 4mm shorter to account for the band taking up space.
This prints without supports at standard .2 layer height, .4 layer width very well.
Print Settings
Printer:
Creality Ender 5 Plus
Rafts:
No
Supports:
No
Infill:
Lines 10 perecent
How I Designed This
How I did the remix
I imported into Blender and then used Boolean modifiers to create additional cylinders and add/subtract geometry as necessary.
Designer
David3d model description
I loved the original Knurled Screw Container (https://www.thingiverse.com/thing:3046847), but it always bothered me that the pattern didn't always lin...e up perfectly depending on how it was screwed in. I also wanted to find a way to do multi color with a single-color printer.So I figured that I could have a 4mm band screw on then be glued with a few dots of super glue to the bottom part. Then the top just needed to be 4mm shorter to have the same overall height and snug fit.
Additionally I thought the inner cavity was smaller than it could be. I was able to increase the inner diameter by 5 mm to a total of 30mm (from 25mm). This makes it more viable for some small storage without affecting strength.
So there are 3 files, one for the new bottom that was wider inner diameter. This can be used with already printed top parts if you dont want the colored band. If you want the colored band, you can print the band part and the new top part that is 4mm shorter to account for the band taking up space.
This prints without supports at standard .2 layer height, .4 layer width very well.
Print Settings
Printer:
Creality Ender 5 Plus
Rafts:
No
Supports:
No
Infill:
Lines 10 perecent
How I Designed This
How I did the remix
I imported into Blender and then used Boolean modifiers to create additional cylinders and add/subtract geometry as necessary.
