Laundry rack repair kit 3D for print
1942 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
There might be better and easier ways to fix a laundry rack,
but what's the point in doing that if you own a 3D printer?
...
Btw, it's still working after two years of almost daily usage \o/
PROTIP:
Two of these clamps, combined with printing filament, can also
be used to span new wires between the existing ones...
Notes:
Do not print the provided STL file. It is only an example.
If you are not familiar with OpenSCAD, feel free to just
edit this file in Thingiverse's Customizer.
Basically, you only need to modify two variables, to create
your own, perfectly fitting Laundry Rack Repair Kit.
the diameter of the frame, "lrDiaFrame"
the diameter of the wire, "lrDiaWire"
Add ~0.5mm - 0.7mm to the measured values.
The example STL was created with
lrDiaFrame = 14.7mm
lrDiaWire = 3.3mm
For a finer control, I recommend editing the OpenSCAD file
directly. It is well documented (TM) and contains a special
"Edit Mode", in which you can examine the (otherwise not
visible) holes and cutouts.
- 2 x 10x3mm screw ...
Designer
FMMT6663d model description
Fix a wire - save a rack!There might be better and easier ways to fix a laundry rack,
but what's the point in doing that if you own a 3D printer?
...
Btw, it's still working after two years of almost daily usage \o/
PROTIP:
Two of these clamps, combined with printing filament, can also
be used to span new wires between the existing ones...
Notes:
Do not print the provided STL file. It is only an example.
If you are not familiar with OpenSCAD, feel free to just
edit this file in Thingiverse's Customizer.
Basically, you only need to modify two variables, to create
your own, perfectly fitting Laundry Rack Repair Kit.
the diameter of the frame, "lrDiaFrame"
the diameter of the wire, "lrDiaWire"
Add ~0.5mm - 0.7mm to the measured values.
The example STL was created with
lrDiaFrame = 14.7mm
lrDiaWire = 3.3mm
For a finer control, I recommend editing the OpenSCAD file
directly. It is well documented (TM) and contains a special
"Edit Mode", in which you can examine the (otherwise not
visible) holes and cutouts.
3d model print parameters
2 x 3mm nut- 2 x 10x3mm screw ...
