Magnetmotor 3D for print
2808 Views 2 Likes 0 Downloads Download
with this kit, you can built your own Magnetmotor.
The Rotor holds 24 Magnets à 3 Rows (72 Magnets 8mm dia. 5m...m hight).
Each Row has a 10 degree offset to the next Row.
The Bores for the Magnets are angled 30 degrees.
The Stator holds also 24 Magnets á 3 Rows (same ammount, same size as above).
No offset of Rows. Also 30 degrees angled.
Rotor to Stator Gap: 4mm
You need two bearings (inner dia.: 10mm, outer dia.: 26mm, hight: 8mm), wich can pressed into the Rotor Support. You also need 20 Screws with plastic thread (3 x 12mm) and 144 Magnets 8mm x 5mm round N48, poles on round faces. You have to print 2 pieces of "Lagerbock.stl" and 3 pieces of "Lagerung_Stator.st".
On this Modell you can slide the Stator over the Rotor. Each bore on the Stator has a service bore, which allows you to pry out the magnets to try different patterns.
Sorry, I haven´t found a pattern which works, but with this model you have the ability to make your own research.
If someone found the right pattern, please let me know!!!!
Have fun!!
Designer
MrCadillacsts3d model description
A kit to built your own magnet motorwith this kit, you can built your own Magnetmotor.
The Rotor holds 24 Magnets à 3 Rows (72 Magnets 8mm dia. 5m...m hight).
Each Row has a 10 degree offset to the next Row.
The Bores for the Magnets are angled 30 degrees.
The Stator holds also 24 Magnets á 3 Rows (same ammount, same size as above).
No offset of Rows. Also 30 degrees angled.
Rotor to Stator Gap: 4mm
You need two bearings (inner dia.: 10mm, outer dia.: 26mm, hight: 8mm), wich can pressed into the Rotor Support. You also need 20 Screws with plastic thread (3 x 12mm) and 144 Magnets 8mm x 5mm round N48, poles on round faces. You have to print 2 pieces of "Lagerbock.stl" and 3 pieces of "Lagerung_Stator.st".
On this Modell you can slide the Stator over the Rotor. Each bore on the Stator has a service bore, which allows you to pry out the magnets to try different patterns.
Sorry, I haven´t found a pattern which works, but with this model you have the ability to make your own research.
If someone found the right pattern, please let me know!!!!
Have fun!!
