This little planter is best printed in normal mode. Set top layers to 0, set infill to 0%. Bottom layers set to 4 or more. Set walls to 3 or more for ...a more sturdy vase. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% of the stl file at 96mm wide for X and Y and Z is 75mm tall. It has not been tested for being watertight. If you make it, please post a photo, I'd like to see your print!
Enjoy...
NoTEs .....look below...
3d model print parameters
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.15 or 0.2
Infill:
0
Filament brand:
stron...ghero
Filament color:
rainbow
Filament material:
pla
Notes:
.....The stl file IS NOT hollow.....Putting 0 top layers on will allow you to put as many walls on as you want, I suggest 3 or more.
DON'T just download and start printing, you will get a nice solid vase, great for a paper weight! Use 0 top layers, 0% infill. I used a wall line width of .8 and a layer height of .2 other widths might work, I haven't tried them. The print should take approximately 2 hour 30 minutes at 50mm/s using 3 walls.