Obelisk with hieroglyphs 3D for print
2957 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
The larger version (18.9cm. tall) was printed in two parts and glued together with a few dabs of Lepage's 'Ultra Gel' superglue. The base (4.7cm. tall) took 1hr 4min. to print and the obelisk-top (14.2cm. tall) took 1hr. 48 min.
All pieces were printed at the default settings of 0.20mm. layer height, 2 shells and 10% infill + raft.
See more of my designs at https://www.thingiverse.com/Winslow/designs
Designer
Colin Winslow3d model description
The obelisk is presented on a classical base. The smaller version (13.9cm. tall), printed in one piece on my Makerbot Replicator, took 1hr 47min. to p...rint.The larger version (18.9cm. tall) was printed in two parts and glued together with a few dabs of Lepage's 'Ultra Gel' superglue. The base (4.7cm. tall) took 1hr 4min. to print and the obelisk-top (14.2cm. tall) took 1hr. 48 min.
All pieces were printed at the default settings of 0.20mm. layer height, 2 shells and 10% infill + raft.
See more of my designs at https://www.thingiverse.com/Winslow/designs
