This flower vase has fins that alternate long then short around the circumference. It can be printed in spiral vase mode or spiralize outer contour in... cura. Or, uncheck spiralize outer contour, set top layers to 0. Set infill to 0%. Bottom layers set to 3 or more. Set walls to 2 or more for a more sturdy vase. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% at 103mm wide and 162mm tall. It has not been tested for being watertight. It is for decorative purposes. If you make it, please post a photo, I'd like to see your print!
Enjoy...
(Notes...... below...... :)
3d model print parameters
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
0
Filament brand:
CC3D
Filam...ent color:
antique gold
Filament material:
pla
Notes:
I use cura's, spiralize outer contour. Check your slicer's view, make sure you are printing a hollow vase with a bottom. The stl file is solid. Use 0 top layers, 0% infill if not printing in vase mode. I used a wall line width of .8, other widths might work, I haven't tried them. The print should take approximately 2 hours using vase mode.