a diamond shaped headphone stand
It was time for a new one, so I sketched, extruded and chamfered one.
Originally it is 200mm in height, but I had t...o split the design for scaling the parts up to 125% to support my headphones.
3d model print parameters
There is a one piece stand (0300) which fits in an UM2 (200mm in height), but it is rather small and it needs a lot of supports.
The two pieces versi...on (0301+0302) is the same dimension but this can be scaled up to fit for bigger headphones (the one on the pictures is printed at 125%) and if printed lying on its back side, only few supports are needed.
- printed from PLA
- supports needed (more or less)