Pebble charger 3D for print
1072 Views 0 Likes 0 Downloads Download
A small USB charger for your Pebble Smartwatch.
Instructions:
Orient the part in your printer as illustrated in one of the images, it was designed to be printed this way. A support structure is not necessary, while a brim helps to prevent warping.
For the connectors: you will need a metal wire that is flexible enough to shape it nicely, but rigid enough to maintain its form in the end. I found that single-core jumper wires do this job just fine. To put the wires in place, you will probably need some tweezers.
Two important notes:
I found that the DIY USB plug works very well. However, as with any non-certified plug, there is always a risk of damage to your equipment. Please be careful and use at your own risk!
Before using, check your print for any sharp edges, especially on the side opposite to the USB plug. Burrs or sharp edges might slightly scratch the plastic housing on the right side of your Pebble.
Have fun!
http://www.instructables.com/id/Pebble-Charger
Special thanks to Acen for sharing his ideas!
- Metal wire (can be a small paper clip or single-core jumper wire)...
Designer
zeq3d model description
A small USB charger for your Pebble Smartwatch. Did you lose your original Pebble charger cable? Or do you want an extra charger, just in case? You ca...n have yours in less than 30 minutes! The design plugs directly in your USB port.A small USB charger for your Pebble Smartwatch.
Instructions:
Orient the part in your printer as illustrated in one of the images, it was designed to be printed this way. A support structure is not necessary, while a brim helps to prevent warping.
For the connectors: you will need a metal wire that is flexible enough to shape it nicely, but rigid enough to maintain its form in the end. I found that single-core jumper wires do this job just fine. To put the wires in place, you will probably need some tweezers.
Two important notes:
I found that the DIY USB plug works very well. However, as with any non-certified plug, there is always a risk of damage to your equipment. Please be careful and use at your own risk!
Before using, check your print for any sharp edges, especially on the side opposite to the USB plug. Burrs or sharp edges might slightly scratch the plastic housing on the right side of your Pebble.
Have fun!
http://www.instructables.com/id/Pebble-Charger
Special thanks to Acen for sharing his ideas!
3d model print parameters
- Printer Filament- Metal wire (can be a small paper clip or single-core jumper wire)...
