Pianoring 3D for print
2246 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
PIANORING
René Magritte said once: “Ceci n'est pas un piano.”. (This is not a piano.)
If you want to print is, it does not make ...music, but you can use it for showing everybody you like pianos.
Till the next design!
Points: 331.677 Edges: 994.782 Faces: 663.040
I have made it, so the logo ...- the flat part of the ring - can be set on the table from the printer, I think that this should be good.
The sizes are in millimeters, the diameter inside. I think the most current sizes are 15, 16, 17, this are the numbers.
Designer
Bruno Bear3d model description
PianoRingPIANORING
René Magritte said once: “Ceci n'est pas un piano.”. (This is not a piano.)
If you want to print is, it does not make ...music, but you can use it for showing everybody you like pianos.
Till the next design!
3d model print parameters
Be course I think that a ring must be smooth, there are a lot of MeshesPoints: 331.677 Edges: 994.782 Faces: 663.040
I have made it, so the logo ...- the flat part of the ring - can be set on the table from the printer, I think that this should be good.
The sizes are in millimeters, the diameter inside. I think the most current sizes are 15, 16, 17, this are the numbers.
