Pop-up gift card box 3D for print
1526 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
This pop-up box adds some extra animation to giving gift cards!
The design makes use of a scissor mechanism to rotate and raise a gift card to the middle of the opened box.
The design comes with 2 box styles and 3 band styles, but it can be easily customized with your own embossed text or patterns to give your gift a special touch!
https://youtu.be/42D3uyLa6v4
The print-in-place hinge has .25mm of clearance all around the axel, which makes two 20mm long bridges. It's printed with the hinge facing down so that the box is open with a 90 degree angle.
Latch Holder.stl is the only file that requires supports.
Assembly
The four latches that hold the card are assembled using 1.75mm filament. The holes for this filament are 2.2mm wide, so this can be a tight fit.
If the holes are too tight, use a 2mm drill bit to open them up slightly.
If the holes are too loose, either use heat to melt and seal the filament into the hole, or use glue to prevent the filament from falling out.
A Larger Clearance version of this design is also available.
Pay close attention to the positioning and orientation of the parts as shown in the video. If Latch_Top.stl is assembled upside down, the mechanism will not fully close.
Designer
3D Printy3d model description
Download files individually if the "Download All" button doesn't work. This is due to a Thingiverse bug that is not generating zip files for new proje...cts.This pop-up box adds some extra animation to giving gift cards!
The design makes use of a scissor mechanism to rotate and raise a gift card to the middle of the opened box.
The design comes with 2 box styles and 3 band styles, but it can be easily customized with your own embossed text or patterns to give your gift a special touch!
https://youtu.be/42D3uyLa6v4
3d model print parameters
The box itself can be printed in two parts (Box_Plain_Top.stl & Box_Plain_Bottom.stl) or as a single piece with a print-in-place hinge (Box_Plain.stl)... .The print-in-place hinge has .25mm of clearance all around the axel, which makes two 20mm long bridges. It's printed with the hinge facing down so that the box is open with a 90 degree angle.
Latch Holder.stl is the only file that requires supports.
Assembly
The four latches that hold the card are assembled using 1.75mm filament. The holes for this filament are 2.2mm wide, so this can be a tight fit.
If the holes are too tight, use a 2mm drill bit to open them up slightly.
If the holes are too loose, either use heat to melt and seal the filament into the hole, or use glue to prevent the filament from falling out.
A Larger Clearance version of this design is also available.
Pay close attention to the positioning and orientation of the parts as shown in the video. If Latch_Top.stl is assembled upside down, the mechanism will not fully close.
