Ultibot Toilet Roll Holder
Ultimaker Robot Head That Holds Your Toilet Rolls.
One Ear Has A Shaft That Holds The Toilet Roll In Place and The Othe...r Ear Rotates To Lock The Center Shaft In Place.
The Slit For The Toilet Paper Is A little Small But The Paper Still Feeds Through Fine. It Just Makes It A Little Fiddly To Feed The Paper Through.
Was Made To Fit The Large Diameter NZ Toilet Rolls So It Should Fit All Sizes
3d model print parameters
Was Printed On UM2+
0.25mm Layer Height
0.8mm Nozzle For Head and Pin
0.4mm Nozzle For Lock, This Is To Get Clear Lettering
1.6mm Wall Thickness ...40mm/s Print Speed with 20mm/s Top/Bottom Print Speed (for Large Overhangs.
Fans 100% For Overhangs.
8% infill For Head And Pin
15% Infill For Lock
No Need For Support as long as you print cold and slow enough.