Print-in-place spring loaded box 3D for print

Designer

SUNSHINE

3d model description

This is my Print in place spring loaded box design! No supports, no assembly, just print and use!
See it in action here: https://youtu.be/IrT1DaSBeQ4...
See it in action here: https://youtu.be/IrT1DaSBeQ4
See it in action here: https://youtu.be/IrT1DaSBeQ4
All clearances are 0.3mm or greater, so most household 3d-printers should have no problems printing it. however, if you suspect you might need a little tuning, I did include a test piece to tune your printer!
I created an Instructables about this project going more into detail about the design choices and tricks that I used to make it work, you can find that here: https://www.instructables.com/id/Print-in-Place-Spring-Loaded-Box/
Important:
Use 0.2mm layer height or finer! (this is due to the overhang being designed for it)
The print should be positioned on its side as shown in the video during printing. (gears down)
Please leave your questions and comments in the comment field, and I’ll do my best to answer them.
Every like is appreciated! Read more

3d model print parameters

0.2mm Layer height
No suports!...

Tags

Print In Place Box Springloaded Mechanical Self Opening No Suports

License

CC Atribution