If you like my work. I will be happy if you support me by donating a few bucks. PayPal Donation.
Hello everyone,
i designed this water reduction... nozzle to save water while having a shower. Especially warm water #hellogascrisis. There are several water reduction systems out there but this is different.
This nozzle intruduce air into the system which reduces water and give a good shower experience. If feels like rain while having a good preasure at the showerhead. At least in my opinion. The principle is based on the venturi effect.
In my case i achived a water reduction of 40%.
NOTE: You need to put a sealing ring into the female thread before mounting. Otherwise it will leak. Mount it between the faucet and the hose to the showerhead
3d model print parameters
Supports:
No
Resolution:
0.1
Infill:
40%
Filament brand:
Sunlu
Filament color:
White
Filament material:
PLA
Notes:
I pr...inted the waternozzle with a nozzle of 0.4mm and used...
Initial layer height: 0.2mm
Layer height: 0.1mm.
Wall line count: 3 or 4
Minimum wall line width: 0.2
note that the male thread must be aligned to the print surface. (so don't try to rotate the nozzle)