Puzzle for little ones 3D for print
5336 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
My granddaughter is almost 9 months old and is learning to fit pieces into others.
So I thought about increasing t...he difficulty of the classic baby puzzle and I designed the pieces with a helical guideline.
I know it is for older ages but it is not bad that I try it from time to time and see how it progresses.
When a piece is slightly inserted into its place, a curious effect is produced: when the piece is released, it begins to rotate as it enters by itself due to the effect of gravity.
The main piece that acts as a perforated box is 30 mm high while the pieces to fit are 50 mm. This allows that when lifting the box with inserted pieces, these take a little longer to come out due to the aforementioned rotation.
On 05/12/2017 I have added a 15 cm pentagonal piece since I have seen that my granddaughter likes to see the piece rotate when inserting it into place. Thus, being longer, it lasts longer.
------------
PLA
0.23mm layer
wall thickness 1 mm
filling 0%
without supports
horizontal expansion = -0.1 mm
It is preferable to u...se a different color for each piece.
No post-processing is necessary.
If you prefer that all the pieces are of the same height, the printing must be stopped when it exceeds 30 mm
Designer
Joan Duatis3d model description
Puzzle for children under 2 yearsMy granddaughter is almost 9 months old and is learning to fit pieces into others.
So I thought about increasing t...he difficulty of the classic baby puzzle and I designed the pieces with a helical guideline.
I know it is for older ages but it is not bad that I try it from time to time and see how it progresses.
When a piece is slightly inserted into its place, a curious effect is produced: when the piece is released, it begins to rotate as it enters by itself due to the effect of gravity.
The main piece that acts as a perforated box is 30 mm high while the pieces to fit are 50 mm. This allows that when lifting the box with inserted pieces, these take a little longer to come out due to the aforementioned rotation.
On 05/12/2017 I have added a 15 cm pentagonal piece since I have seen that my granddaughter likes to see the piece rotate when inserting it into place. Thus, being longer, it lasts longer.
3d model print parameters
materials------------
PLA
0.23mm layer
wall thickness 1 mm
filling 0%
without supports
horizontal expansion = -0.1 mm
It is preferable to u...se a different color for each piece.
No post-processing is necessary.
If you prefer that all the pieces are of the same height, the printing must be stopped when it exceeds 30 mm
