Raketti toy / puzzle 3D for print
2073 Views 2 Likes 1 Downloads Download the piece here from 3dforprint
Real... crowd pleaser, pops out with a fun little noise.
Considered a puzzle but I usually just show people what it's about before handing it to them.
.
One version is like in the video, with or without magnet holes*.
The flat version is something I saw here, and it's also cool:
http://www.grand-illusions.com/acatalog/Raketti.html
.
* The magnet holes are for cylindrical neodymium magnets, 3x5mm in part A and 3x3mm in part B. Any less, and part A still pops out if you blow hard right into the gap. I'm not a huge fan of the magnet trick, but you might as well do it right if you do it. For magnets, I recommend ordering 3x1mm pieces and stacking them as needed (on dx they're like $4 for 100). Or just order some 3x3 and 3x5 pieces, they're more fun. In any case, I would leave a bit of space in the hole and top it off with something, maybe the same glue I use for the magnet, because I've had issues with magnets coming loose (also make sure to wipe the magnets clean of any oils before gluing).
Designer
annotatedsnark3d model description
Simple toy, you blow on it just right, and the cylinder pops out satisfyingly. Also there's an optional magnet trick you can play on a "victim".Real... crowd pleaser, pops out with a fun little noise.
Considered a puzzle but I usually just show people what it's about before handing it to them.
.
One version is like in the video, with or without magnet holes*.
The flat version is something I saw here, and it's also cool:
http://www.grand-illusions.com/acatalog/Raketti.html
.
* The magnet holes are for cylindrical neodymium magnets, 3x5mm in part A and 3x3mm in part B. Any less, and part A still pops out if you blow hard right into the gap. I'm not a huge fan of the magnet trick, but you might as well do it right if you do it. For magnets, I recommend ordering 3x1mm pieces and stacking them as needed (on dx they're like $4 for 100). Or just order some 3x3 and 3x5 pieces, they're more fun. In any case, I would leave a bit of space in the hole and top it off with something, maybe the same glue I use for the magnet, because I've had issues with magnets coming loose (also make sure to wipe the magnets clean of any oils before gluing).
