Rolling storage box 3D for print
2097 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
Pick a size (small, medium, or large) and 8 bins that match your storage needs (you must include... a "start" and "end" bin).
Connect the bins by inserting a short piece of filament into each hinge joint.
https://youtu.be/Cm5bByFYJKk
Doesn't Matter
Supports:
No
Infill:
10-20%
Notes:
Print orientation
Print all bins, cores, and lid with the largest flat si...de down.
Print the optional label piece on its side
Do not print the pin files unless they are placed within the bin hinge (print-in-place)
Recommended
Print bins individually and attach by inserting a short piece of raw filament in each hinge. While it's possible to use the included pin files to make a print-in-place hinge, printing the bins individually will allow you to switch out bins in the future.
If the filament falls out of the hinge too easily, a small drop of hot glue in the hinge hole will seal it in.
Infill
Infill is only relevant for the start/end bins, the core, and the cap. The other parts are just thin walls and won't require infill as long as you print with 3 perimeters.
Designer
3D Printy3d model description
This is a customizable rolling storage bin system.Pick a size (small, medium, or large) and 8 bins that match your storage needs (you must include... a "start" and "end" bin).
Connect the bins by inserting a short piece of filament into each hinge joint.
https://youtu.be/Cm5bByFYJKk
3d model print parameters
Rafts:Doesn't Matter
Supports:
No
Infill:
10-20%
Notes:
Print orientation
Print all bins, cores, and lid with the largest flat si...de down.
Print the optional label piece on its side
Do not print the pin files unless they are placed within the bin hinge (print-in-place)
Recommended
Print bins individually and attach by inserting a short piece of raw filament in each hinge. While it's possible to use the included pin files to make a print-in-place hinge, printing the bins individually will allow you to switch out bins in the future.
If the filament falls out of the hinge too easily, a small drop of hot glue in the hinge hole will seal it in.
Infill
Infill is only relevant for the start/end bins, the core, and the cap. The other parts are just thin walls and won't require infill as long as you print with 3 perimeters.
