Add these to your decorations and witness joy to the world spring up from them this Christmas!
This design is based on the Aizawa strange attractor.... The original shape has been stretched and tapered at both ends to minimize the need for supports, and beveled with a star-shaped curve. Supports are only needed for the bottom ~15 mm, mostly to ensure the print stays on the print bed.
3d model print parameters
PLA
Print settings:
- Layer height: 0.2 mm
- Walls / Perimeters: 3
- Infill: 0
- Supports: For the first 15 mm, to keep it on the print bed. ...