Use the 'download' button under the 'thing files'. For some reason Thingiverse started giving me/lots of us, this 404 error.
This vase can be print...ed in vase mode or spiralize outer contour in cura, or printed in normal mode. You can uncheck spiralize outer contour, set top layers to 0, set infill to 0%. Bottom layers set to 3 or more. I wouldn't recommend setting the walls to more than 2, you'll get a lot of infill in those fins....check your slicer specs. Can be scaled to fit your needs. The photo shows vase not scaled at 100% of the stl file at 79mm wide for X and Y and Z is 110mm tall. It has not been tested for being watertight and probably isn't printed in vase mode. If you make it, please post a photo, I'd like to see your print!
Enjoy...
(Notes below...... :)
3d model print parameters
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.8 is best
Infill:
0
Filament brand:
3d Sol...utech
Filament color:
mint
Filament material:
pla
Notes:
The stl file is not hollow.
The fins will print the best if using a .8 'Wall line width'. A .4 or .6 wall can be used if printing 1 wall. Cura will put infill in the fins if printing 2 or more walls and result in a 7-8 hour print. Which is fine if that's what you want. Check your slicer.
Don't just blindly download and start printing, you will get a nice solid vase, great for, well I don't know what for, but not a pencil holder! The print should take approximately 3 hour 30 minutes at 40mm/s using vase mode.