Side table for ikea solvinden 3D for print
3764 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
I have create a side table to mount on an IKEA Solvinden solar powered floor LED lamp.... Two versions are uploaded, one (dual1 and dual2) are targeted at dual extrusion machines, and the mono version is for a single extrusion machine.
The table can be mounted on the lamp by unscrewing the top rod. It rests on the knob between the two rods. The top plate is a little bit skewed and has water drain holes in the center.
I have only printed the dual version, so did not test the STL of the mono version. Any feedback is welcome.
Note: use the table at own risk, do not overload and be aware that PLA will degrade over time especially in outside conditions.
Marco
Designer
Marco3D3d model description
A side table to mount on an IKEA Solvinden Floor Lamp LED lightI have create a side table to mount on an IKEA Solvinden solar powered floor LED lamp.... Two versions are uploaded, one (dual1 and dual2) are targeted at dual extrusion machines, and the mono version is for a single extrusion machine.
The table can be mounted on the lamp by unscrewing the top rod. It rests on the knob between the two rods. The top plate is a little bit skewed and has water drain holes in the center.
I have only printed the dual version, so did not test the STL of the mono version. Any feedback is welcome.
Note: use the table at own risk, do not overload and be aware that PLA will degrade over time especially in outside conditions.
Marco
