Small table, side table 3D for print
3335 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
Some comments;You'll have to print both parts... 2x, the thing is not symetrical!The holes for the bolts are a bit short, I would advice adding 5mm.Holes are for M8 bolts
I had some underextrusion at some of the prints, last part came out perfect at:
layer: 0,2Shell: 1,2Fill: 30%Speed 30 mm/s
This was a 25 hour print (!) but any higher speed resulted in underextrusion on my machine.
- 4 m8 bolts
- wooden legs...
Designer
UltiArjan3d model description
Side table. My first attempt to create something "really big" Made of 4 parts, connected with M8 bolts.Some comments;You'll have to print both parts... 2x, the thing is not symetrical!The holes for the bolts are a bit short, I would advice adding 5mm.Holes are for M8 bolts
I had some underextrusion at some of the prints, last part came out perfect at:
layer: 0,2Shell: 1,2Fill: 30%Speed 30 mm/s
This was a 25 hour print (!) but any higher speed resulted in underextrusion on my machine.
3d model print parameters
- pla- 4 m8 bolts
- wooden legs...
