Disc chain
It is inspired by the Gran Ilusions video about finger fidgets minute 4:28:
It is for very nervous people who need to be doing something ...with their fingers (finger fidgets) therefore it has anti-stress effects
3d model print parameters
materials
-----------
PLA
wall thickness 1 mm
Fill 0%
Horizontal expansion = -0.1
Adhesion: 4mm edge
Print 6 discs (3 of one color and 3 of a...nother color)
To make the clamps strong, they must be printed in the right direction. Therefore, the printing position of the disc is important. I have tried several positions and the only one that has worked for me is the initial one that has the stl. That is, do not rotate the position of the piece
For that reason it must be printed with supports everywhere.
Print 6 axes of a single print.
At the end you have to remove the supports, go over the hole with a circular file and finish sanding the areas in contact with the support to improve the finish.
Snap the shafts into the center hole so that they protrude the same on both sides of the disc.
Snap hooks of one color to the shaft corresponding to the other color