I started with a version1 based on a mirrored baseblock of foehnsturm, but due to the asymmetrical rod placement you would lose more buildspace then necessary. I managed to get an almost symmetrical rod placement.
Some remarks;
- you can use this head with the default UM2 firmware, but the margins are small. I only have 1mm of space between the block on the front of the printer when starting a print.
- if you create your own alternative mounts (paste struder, plotter, full metal head,... many projects possible..) you will need to reduce the XY margins in firmware.
- for cable management take 2 tie wraps of the same small size, from 1 you only need the head, mount as in the picture.
- For mounting and un-mounting; remove filament and bowden tube, remove the 2 long screws at the left side.
- To remove the 3 original black plastic parts you don't need to remove cables at the printboard side, the fans have connectors in the black sleeve you can easily clip/unclip.
- Mark your XY rods before removal (they are not the same length) and check how far they need to stick out to touch the endswitch.
- MAKE SURE to level your bed after installation !!
- If you create an alternative mount for this, please share it, preferably including the step file.
- I printed mine with 0.1 layer, 50% fill, 1,2 shell, 35 mm/s
- "Mount_v2i2e.stl" has 1 build in support you can easily take out with a small plier, no need for additional support in cura.