Springo stool 3D for print
983 Views 0 Likes 0 Downloads Download
1. It is easy to assemble
2. Comfortable (Use of springs)
3. One can increase or decrease the height according ...to preference (By removing or adding 3D Printed parts).
4. The Stool slightly Bends according to your Body Movement...Hence Relieving the strain caused due to sitting for Long hours!.
The Springs snugly fit into the 3D Printed parts.
You need to PRINT :
16 PIECES OF A
2 PIECES OF B
4 PIECES OF C
8 PIECES OF D
Springs ( Inner dia : 20mm) and hieghts : 7cm, 9cm, 11.5cm, 14cm.
And a Circular wooden Board of dia : 44cm and thickness : 1.2 to 1.5cm.
Screw the Wooden Board to the top 4 D Brackets.
This can be printed on most printers of print bed 210x240mm minimum.
Or you can divide the D Parts into halves and Print!
#DAGOCULTS
HAPPY PRINTING!
Layer Thickness : 0.3mm (300 microns)
Support material required on Build Plate only (For parts A,B & C).
NO Support for D Parts....
Designer
DHRUV3d model description
This is a modular 3D Printed Stool.1. It is easy to assemble
2. Comfortable (Use of springs)
3. One can increase or decrease the height according ...to preference (By removing or adding 3D Printed parts).
4. The Stool slightly Bends according to your Body Movement...Hence Relieving the strain caused due to sitting for Long hours!.
The Springs snugly fit into the 3D Printed parts.
You need to PRINT :
16 PIECES OF A
2 PIECES OF B
4 PIECES OF C
8 PIECES OF D
Springs ( Inner dia : 20mm) and hieghts : 7cm, 9cm, 11.5cm, 14cm.
And a Circular wooden Board of dia : 44cm and thickness : 1.2 to 1.5cm.
Screw the Wooden Board to the top 4 D Brackets.
This can be printed on most printers of print bed 210x240mm minimum.
Or you can divide the D Parts into halves and Print!
#DAGOCULTS
HAPPY PRINTING!
3d model print parameters
Infill: 50%Layer Thickness : 0.3mm (300 microns)
Support material required on Build Plate only (For parts A,B & C).
NO Support for D Parts....
