Blinky timer 3D for print
725 Views 0 Likes 0 Downloads Download
This is a timer that blinks green for a set amount of time, then yellow, then red when you push a reces...sed button. The face of the timer has the total time printed into it. (You can use the STL, or go into openscad and substitute the number/text of your choosing). It uses a lithium 3v coin cell and should be good for a few hundred cycles (deep sleep between activations).
The timer program uses the internal clock of the ATTiny85 chip, which is not that accurate (but pretty repeatable) so you will have to adjust the delay numbers to get your version most accurate. You can also print a new faceplate and program for a different time.
Also included: a Fritzing file for the connections and for making a PCB should you choose to. (I am planning an order from Osh Park because soldering the perfboard version is a pain.)
-ATTiny85 (or smaller)
-perfboard or circuit board
-2 x 180 or 220 ohm resistors
-wire
-8-pin socket optional
...
-RGB common-cathode LED
-small SPST momentary switch
Designer
rp100073d model description
Minimal color-coded timer for staying on taskThis is a timer that blinks green for a set amount of time, then yellow, then red when you push a reces...sed button. The face of the timer has the total time printed into it. (You can use the STL, or go into openscad and substitute the number/text of your choosing). It uses a lithium 3v coin cell and should be good for a few hundred cycles (deep sleep between activations).
The timer program uses the internal clock of the ATTiny85 chip, which is not that accurate (but pretty repeatable) so you will have to adjust the delay numbers to get your version most accurate. You can also print a new faceplate and program for a different time.
Also included: a Fritzing file for the connections and for making a PCB should you choose to. (I am planning an order from Osh Park because soldering the perfboard version is a pain.)
3d model print parameters
Translucent PLA or ABS or whatever-ATTiny85 (or smaller)
-perfboard or circuit board
-2 x 180 or 220 ohm resistors
-wire
-8-pin socket optional
...
-RGB common-cathode LED
-small SPST momentary switch
