Super mario pen/pencil holder 3D for print
1908 Views 1 Likes 1 Downloads Download
The flagpole is a pencil. The flag.stl and flag_base.stl have an 8.5mm hole in them. It was a bit too large for the pencil I used, but fits a standard Bic Round Stick pen. You can scale the base and flag a bit to get the right fit if needed.
The mushrooms are my design as well. Get those here:
http://www.thingiverse.com/thing:1375575
Fusion3 F400-S
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
25% for small parts and 15% for large parts.
Notes:
I u...sed such a course resolution because the parts are low detail and quite large. The only part I printed with different settings was the flag. On that one, I slowed my speed down to about 35mm/s and printed two at a time (after printing the one in the picture). It came out perfectly. I used Matterhackers ABS to print this.
Post-Printing
Painting
The featured picture of the print is without cleanup, priming, etc. I plan to finish this at some point and will update the pictures once I have painted the model.
Designer
andrewbougie3d model description
It's a (very large) Super Mario pen and pencil holder! There are several configurations available depending on how much desktop space you have and how... much filament you want to use. The rendered images after the photo show some options.The flagpole is a pencil. The flag.stl and flag_base.stl have an 8.5mm hole in them. It was a bit too large for the pencil I used, but fits a standard Bic Round Stick pen. You can scale the base and flag a bit to get the right fit if needed.
The mushrooms are my design as well. Get those here:
http://www.thingiverse.com/thing:1375575
3d model print parameters
Printer:Fusion3 F400-S
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
25% for small parts and 15% for large parts.
Notes:
I u...sed such a course resolution because the parts are low detail and quite large. The only part I printed with different settings was the flag. On that one, I slowed my speed down to about 35mm/s and printed two at a time (after printing the one in the picture). It came out perfectly. I used Matterhackers ABS to print this.
Post-Printing
Painting
The featured picture of the print is without cleanup, priming, etc. I plan to finish this at some point and will update the pictures once I have painted the model.
