Super strong arm 3D for print
2812 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
This arm was made to support objects with a mass equal or higher than 1kg with an ajustable position.
In my case I reu...sed an old phone/table holder and my objective was to support an old and heavy Samsung tablet to see movies/streams while I'm lying.
This arm weights less than 200g in PLA (it can vary with the definitions used in slicer).
Note: This arm is not the final version. The end arm is for my old support, anyway I provide the openscad (with some bugs and not totally optimized that I will try to correct) so you can change the purpose of the arm. I didnt't make the headers adaptable too, but I'll try to make them in the next version.
If you have any question please contact me!
•3 metal slotted screws (4mm*30mm);
•3 metal nuts (4mm);
•3 metal washers (4mm);
MY print specs:
•Ender... 3 with BQ black PLA;
•Layer height: 0,2mm;
•Support and support helper with 100% (it's not needed);
•The other prints with 30% infill and 5 layers of thickness.
Designer
mingamobs3d model description
Strong arm that support 1kg+This arm was made to support objects with a mass equal or higher than 1kg with an ajustable position.
In my case I reu...sed an old phone/table holder and my objective was to support an old and heavy Samsung tablet to see movies/streams while I'm lying.
This arm weights less than 200g in PLA (it can vary with the definitions used in slicer).
Note: This arm is not the final version. The end arm is for my old support, anyway I provide the openscad (with some bugs and not totally optimized that I will try to correct) so you can change the purpose of the arm. I didnt't make the headers adaptable too, but I'll try to make them in the next version.
If you have any question please contact me!
3d model print parameters
This design is complemented by:•3 metal slotted screws (4mm*30mm);
•3 metal nuts (4mm);
•3 metal washers (4mm);
MY print specs:
•Ender... 3 with BQ black PLA;
•Layer height: 0,2mm;
•Support and support helper with 100% (it's not needed);
•The other prints with 30% infill and 5 layers of thickness.
