Printshade 150 - tom dixon's etch shade inspired lamp 3D for print
850 Views 0 Likes 0 Downloads Download
Attribution
Tom Dixon's Etch Shade...
1x cara150_pA.stl
1x cara150_pB.stl
20x cara150.stl
1x cubrecable.stl
1 x M3 bolt to restrain the wire inside the "etc...h120_sopcable2.stl"
Wire (5-6mm external diameter)
1 x light bulb base (maybe you need a plastic clamp to atach the wire inside the base)
96 x 2-2.5 mm width white plastic clamps to join the faces
1 x plastic clamp to make the pendant tie with the wire
1 x spotted omni directional bulb (no LED or white bulb, you need a point light or concentrated light to guet the best results). A good one is an halogen bulb http://www.cherylpettdesign.com/wp-content/uploads/2014/02/halogen.jpg
Designer
Egrojyos3d model description
PrintShade 150 - Tom Dixon's Etch Shade inspired Lamp. This is a bigger version from the other one I've madeAttribution
Tom Dixon's Etch Shade...
3d model print parameters
3x cara150_cable.stl.stl1x cara150_pA.stl
1x cara150_pB.stl
20x cara150.stl
1x cubrecable.stl
1 x M3 bolt to restrain the wire inside the "etc...h120_sopcable2.stl"
Wire (5-6mm external diameter)
1 x light bulb base (maybe you need a plastic clamp to atach the wire inside the base)
96 x 2-2.5 mm width white plastic clamps to join the faces
1 x plastic clamp to make the pendant tie with the wire
1 x spotted omni directional bulb (no LED or white bulb, you need a point light or concentrated light to guet the best results). A good one is an halogen bulb http://www.cherylpettdesign.com/wp-content/uploads/2014/02/halogen.jpg
