Ultimaker extruder mutli clip 3D for print
909 Views 0 Likes 0 Downloads Download
This gadget clips onto the Bowden cable retainer on the top of the Ultimaker extruder. It makes retractions work considerably better (discussed here: http://groups.google.com/group/ultimaker/browse_thread/thread/7537389e8085beaf#)
This is a different take on the remarkably effective and simple Quick Connect Shim (http://www.thingiverse.com/thing:22851). I found my shim would fall out from time to time, so I made this one which has multiple thicknesses, and (I think) clips on slightly better. It's also easier to remove, and slightly harder to lose ;-)
This takes about 2 minutes to print, and doesn't need any special settings.
Designer
Coofer Cat3d model description
This gadget clips onto the Bowden cable retainer on the top of the Ultimaker extruder. It makes retractions work considerably better (discussed here: ...http://groups.google.com/group/ultimaker/browse_thread/thread/7537389e8085beaf#)This gadget clips onto the Bowden cable retainer on the top of the Ultimaker extruder. It makes retractions work considerably better (discussed here: http://groups.google.com/group/ultimaker/browse_thread/thread/7537389e8085beaf#)
This is a different take on the remarkably effective and simple Quick Connect Shim (http://www.thingiverse.com/thing:22851). I found my shim would fall out from time to time, so I made this one which has multiple thicknesses, and (I think) clips on slightly better. It's also easier to remove, and slightly harder to lose ;-)
This takes about 2 minutes to print, and doesn't need any special settings.
![[WIP] CerbrisReborn 1.75mm bowden extruder](https://www.3dforprint.com/modelos/4801/wip-cerbrisreborn-mm-bowden-extruder1_medium.jpg)
