Ultimaker2 knob 3D for print
4129 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
Print in ABS for best fit. For PLA you might need to adjust the center whole ...with a tool.
Pry the knob from the Ultimaker2 by using 2 tools, one on each side. You need only the knob not the light ring around it!
Attach the new knob. Don't use a lot of force. If it doesn't fit use a tool to widen the center whole a bit.
Edit: Changed the design of the center whole a bit. It should be a snugly fit even with building tolerances.
Designer
restinpieces3d model description
A new knob for the Ultimaker2 with a nice rim and a wider finger-pocketPrint in ABS for best fit. For PLA you might need to adjust the center whole ...with a tool.
Pry the knob from the Ultimaker2 by using 2 tools, one on each side. You need only the knob not the light ring around it!
Attach the new knob. Don't use a lot of force. If it doesn't fit use a tool to widen the center whole a bit.
Edit: Changed the design of the center whole a bit. It should be a snugly fit even with building tolerances.
