Ultimaker 2 - 36mm spool holder v1.2 3D for print
7974 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
T...his is a single-spool design, but I wrote parametric source, so if someone needs a longer, wider, or thinner spindle, I will gladly generate additional models.
v1.0 held the spool as I added features to and printed this version.
v1.1 enjoys a better spindle end stop, chamfered spindle cuff offset, and a small rail on the mount's upper tab to improve leveling.
v1.2 boasts a slightly longer spindle, improving spool compatibility (thanks to gbo for the suggestion!)
I didn't cut away as much as I could, but since only one is needed, I opted for solidity.
Designer
Peter3d model description
This was designed for the spools shipped by MakerFarm, which have an approximately 36mm hole, which doesn't fit the stock Ultimaker 2 spool holder.T...his is a single-spool design, but I wrote parametric source, so if someone needs a longer, wider, or thinner spindle, I will gladly generate additional models.
v1.0 held the spool as I added features to and printed this version.
v1.1 enjoys a better spindle end stop, chamfered spindle cuff offset, and a small rail on the mount's upper tab to improve leveling.
v1.2 boasts a slightly longer spindle, improving spool compatibility (thanks to gbo for the suggestion!)
I didn't cut away as much as I could, but since only one is needed, I opted for solidity.
