Inside wall corner trowel 3D for print
1355 Views 0 Likes 0 Downloads Download
Wall cornering trowel that can be used to help shape drywall during constructio...n or any other application where a 90 degree angle is needed to be shaped.
Print the two parts separately and then slide the handle into either end of the main tool part and they should fit snugly. Glue is recommended but not necessary.
0.15mm layer height for both parts is sufficient, even 0.20mm works fine.
Use supports only on the handle part
...
Once the supports are taken off of the handle part and the handle is sanded smooth, insert it into either side of the main part until snug. It is recommended to use glue but is not necessary.
Designer
matthewpollack3d model description
A tool used to help shape corners of drywall used during constructionWall cornering trowel that can be used to help shape drywall during constructio...n or any other application where a 90 degree angle is needed to be shaped.
Print the two parts separately and then slide the handle into either end of the main tool part and they should fit snugly. Glue is recommended but not necessary.
3d model print parameters
PLA or any other rigid material0.15mm layer height for both parts is sufficient, even 0.20mm works fine.
Use supports only on the handle part
...
Once the supports are taken off of the handle part and the handle is sanded smooth, insert it into either side of the main part until snug. It is recommended to use glue but is not necessary.
