Um2 - plexi hook 3D for print
1166 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
print 2 pieces (one mirrored if you want to)
Assembly:
- place the hooks on top of the plexiglass...
- mark the holes
- remove the hooks and drill the holes (do it slowly or it may crack)
- cut the tip of the filament flat, chamfer a little bit (1mm)
- push the filament in the hole as much as you can, cut the filament (small cut then break it)
- with the drill and drill bit push the filament a little further in.
- clean
- enjoy
- an Acrylic glass of 11"X 12" X 3mm thick.
- a drill and drill bit 7/64 or 2.75mm,
- 1 piece of 2.85mm filament,
- 1 exacto or som...ething that cut.
Designer
pmdude3d model description
hooks to hold acrylic glass on front of UM2print 2 pieces (one mirrored if you want to)
Assembly:
- place the hooks on top of the plexiglass...
- mark the holes
- remove the hooks and drill the holes (do it slowly or it may crack)
- cut the tip of the filament flat, chamfer a little bit (1mm)
- push the filament in the hole as much as you can, cut the filament (small cut then break it)
- with the drill and drill bit push the filament a little further in.
- clean
- enjoy
3d model print parameters
You'll need:- an Acrylic glass of 11"X 12" X 3mm thick.
- a drill and drill bit 7/64 or 2.75mm,
- 1 piece of 2.85mm filament,
- 1 exacto or som...ething that cut.
